2-5
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 2 Using the setup Command Facility
Completing the Configuration
!
interface FastEthernet0/0
media-type 100BaseX
half-duplex
ip address 9.13.38.150 255.255.255.0
!
interface FastEthernet0/1
shutdown
no ip address
dialer-list 1 protocol ip permit
!
end
Completing the Configuration
When you have all the information that the setup command facility has prompted you for, the
configuration appears.
To complete your configuration, follow these steps:
Step 1
A setup command facility prompt asks if you want to save this configuration, with the following options:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you answer
0
, the configuration information you entered is
not
saved, and you return to the Cisco VG
enable prompt (
VG#
). Enter
setup
to return to the System Configuration Dialog.
If you answer
1
, you return to setup without saving the configuration.
If you answer
2
, the configuration is saved and you are returned to the user EXEC prompt
(VG>)
.
Step 2
When the messages stop appearing on your screen, press
Return
to get the
VG>
prompt.
Step 3
The
VG>
prompt indicates that you are now at the command-line interface (CLI) and you have just
completed a basic Cisco VG configuration. However, this is
not
a complete configuration. At this point
you have two choices:
•
Run the setup command facility again and create another configuration. Enter the following:
VG>
enable
Password:
password
VG#
setup
•
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, “Configuring with the Command-Line Interface.”
