1-7
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 1 Understanding Interface Numbering and Cisco IOS Software Basics
Where to Go Next
Where to Go Next
Now that you have learned some Cisco IOS software basics and seen a typical deployment scenario, you
can begin to configure the VG by using the command-line interface (CLI).
Remember that:
•
You can use the question mark (?) and arrow keys to help you enter commands.
•
Each command mode restricts you to a set of commands. If you have difficulty entering a command,
check the prompt and then enter the question mark (
?
) for a list of available commands. You might
be in the wrong command mode or be using the wrong syntax.
•
To disable a feature, generally enter the keyword
no
before the command; for example,
no ip
routing
.
•
You need to save your configuration changes to NVRAM so that the changes are not lost if there is
a system reload or power outage.
Go to
Chapter 2, “Using the setup Command Facility,”
to begin configuring the VG.
