3-31
Cisco UCS C420 Server Installation and Service Guide
OL-27640-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Figure 3-17
CPU and Pick-and-Place Tool on Pedestal
Step 8
Install a new CPU:
a.
Set the Pick-and-Place tool that is holding the CPU over the empty CPU socket on the motherboard.
Note
Align the arrow on the top of the tool with the registration mark (small triangle) that is stamped
on the metal of the CPU socket, as shown in
Figure 3-16 on page 3-30
.
b.
Press the top button on the tool to set the CPU into the socket. Remove the empty tool.
c.
Close the hinged CPU cover plate.
d.
Clip down the CPU retaining latch with the
icon, then clip down the CPU retaining latch
with the
icon. See
Figure 3-14 on page 3-29
.
Step 9
Install a heatsink:
Caution
The heatsink must have a new, undamaged thermal pad on the heatsink-to-CPU surface to ensure proper
cooling. If you are reusing a heatsink, you must remove the old thermal pad. If you are installing a new
heatsink, skip to Step
d.
below.
a.
Apply an alcohol-based cleaning solution to the old thermal pad and let it soak for a least 15
seconds.
b.
Wipe all of the old thermal pad off the old heatsink using a soft cloth that will not scratch the
heatsink surface.
c.
Apply thermal grease from an included syringe to the top of the CPU.
1
Arrow marks for alignment
1
1
1
333566
