Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05
5-17
Type a number (1 through 99) or type “0” to permit access to all IP addresses, and press
Enter
.
Enter Access list number allowing access with this community string, use
‘0’ to allow all:
Step 5
The maximum number of GET communities is 20.
•
To add more entries, type
y
and press
Enter
•
Would you like to add another SNMP GET community? [no]:
y
Enter up to 20 SNMP GET communities as described in step 3 and step 4.
•
When all entries have been added, press
Enter
Would you like to add another SNMP GET community? [no]:
Step 6
Type the SNMP SET community name and press
Enter
.
The SNMP agent that resides inside the
SCE 1000
will respond only to SET requests that use this
community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Step 7
Assign an access list to restrict the SNMP management stations that may use this SET community.
Type a number (1 through 99) or type “0” to permit access to all IP addresses, and press
Enter
.
Enter Access list number allowing access with this community string, use
‘0’ to allow all:
Step 8
The maximum number of SET communities is 20.
•
To add more entries, type
y
and press
Enter
Would you like to add another SNMP SET community? [no]:
y
Enter up to 20 SNMP SET communities as described in step 6 and step 7.
•
When all entries have been added, press
Enter
Would you like to add another SNMP SET community? [no]:
Step 9
Enter the SNMP trap managers menu.
Would you like to configure SNMP trap managers? [no]:
y
Type
y
and press
Enter
.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure
trap status. (See step 14.)
Step 10
Type the trap manager IP address and press
Enter
.
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Step 11
Type the trap manager community string and press
Enter
.
Note that there is no default for this parameter.
Enter SNMP trap manager community string:
Step 12
Type the number of the trap manager SNMP version (1 or 2c) and press
Enter
