Chapter 7 Basic SCE 1000 Platform Operations
Displaying the System Uptime
Cisco SCE 1000 2xGBE Installation and Configuration Guide
7-10
OL-7821-05
Displaying the System Uptime
Use this command to see how long the system has been running since the last reboot.
To show the system uptime for the SCE platform, use the following command:
At the
SCE 1000
#
prompt, type
show system-uptime
and press
Enter
.
The system shows how long the system has been running since the last reboot.
E
XAMPLE
:
The following example shows how to display the system uptime of the SCE platform.
SCE 1000
#
show system-uptime
SCE 1000
uptime is 21 minutes, 37 seconds
SCE 1000
#
Rebooting and Shutting Down the SCE Platform
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new firmware, in order for that firmware
to take effect. There might be other occasions where rebooting the SCE platform is necessary.
Note
When the SCE restarts, it loads the startup configuration, so all changes made in the running
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
Saving the Configuration Settings
(on page
7-5
).
To reboot your SCE platform, complete the following steps:
Step 1
At the
SCE 1000
#
prompt, type
reload
and press
Enter
.
A confirmation message appears.
Step 2
Type
Y
to confirm the reboot request and press
Enter
.
E
XAMPLE
:
The following example shows the commands for system reboot.
SCE 1000
# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
