Chapter 4 Installation and Maintenance
Fan Module Overview
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05
4-21
To remove the fan module, complete the following steps:
Step 1
Using a 1/4-inch flat-blade screwdriver, loosen the two captive screws on the faceplate of the fan
module.
Step 2
Grasp the fan module handle and remove it from the router.
This completes the procedure for removing the fan module from a
SCE 1000
platform.
Replacing the Fan Module
To install a new fan module into a
SCE 1000
platform, complete the following steps:
Step 1
Grasp the fan module handle with one hand and place your other hand underneath the fan module
for support. The handle of the unit should be at the bottom.
Step 2
Fit the groove in the side of the new fan module into the guide in the chassis.
Step 3
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear
panel.
Figure
4-17: Inserting the Fan Module
Warning
When inserting a fan module into the
SCE 1000
platform, do not use unnecessary force; slamming the
fan module into the chassis can damage the connectors on the rear of the module.
Step 4
Seat the fan module in the
SCE 1000
platform by tightening the two captive installation screws
with a 1/4-inch flat-blade screwdriver.
Note
The fan module is not fully seated until you tighten the installation screws on the faceplate.
This completes the procedures for replacing a fan module in a
SCE 1000
platform.
