Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
37
3
When the Internet Connection Type is PPPoE:
In the
PPPoE Settings
section, enter the following information
:
802.1p Priority
Enter a range from 0 to 7. All outbound traffic of this
interface will be tagged with the configured 802.1p
priority. If it conflicts with the QoS setting, the QoS
setting will take precedence.
MTU (Maximum
Transmission Unit)
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
Size
Enter the size of bytes. (Range 576 - 1500, Default
1500).
MAC Address Clone
Sometimes, you may need to set the MAC address of
the device WAN port to be identical to your PC or
some other MAC address. This is called MAC address
cloning.
For example, some ISPs register your computer card
MAC address when the service is first installed. When
you place a router behind the cable modem or DSL
modem, the MAC address from the device WAN port is
not recognized by the ISP.
In this case, to configure your device to be recognized
by the ISP, you can clone the MAC address of the WAN
port to be the same as your computer MAC address.
To configure a MAC address clone select Enable.
MAC Address
To set the MAC address of the device WAN port, do
one of the following:
To set the MAC address of the WAN port to your PC
MAC address, click
Clone My PC’s MAC
.
To specify a different MAC address, enter it in the
MAC
Address
field.
Username
Enter the username.
Password
Enter the password.
