Cisco ONS 15310-MA SDH, Procedure Manual, Page: 563 / 632

18-63
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 18 DLPs H200 to H299
Step 6
Return to your originating procedure (NTP).
DLP-H260 Route Cables
Step 1 As needed, install a tie-bar or other strain-relief device, according to local site practice.
Caution
You must provide some type of strain relief for the ONS 15310-MA SDH cabling.
Step 2
Route the cables to the appropriate side of the shelf assembly according to local site practice.
Step 3 Secure the cables to the strain-relief device using tie-wraps or other site-specific methods.
Step 4
Label all cables at each end of the connection to avoid confusion with cables that are similar in
appearance.
Step 5
Return to your originating procedure (NTP).
DLP-H264 Clear All PM Thresholds
Caution
Pressing the Reset button can mask problems if used incorrectly. This button is commonly used for
testing purposes.
Purpose This task routes electrical, optical, alarm, and timing cables away from the
ONS 15310-MA SDH. You can install optional tie-bars specifically
designed for the ONS 15310-MA SDH.
Tools/Equipment Tie-wraps or other securing devices, according to local practice
Tie-bar(s)
Prerequisite Procedures NTP-H158 Install the Electrical Cables, page 1-27
NTP-H160 Install Optical Cables, page 1-29
NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin
Connections, page 1-26
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
Purpose This task clears and resets all PM thresholds to default values.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only