Cisco ONS 15310-MA SDH, Procedure Manual, Page: 404 / 632

16-114
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 16 DLPs H1 to H99
DLP-H97 Monitor PM Counts for Selected Signal Types
Step 1
In node view, double-click a 15310E-CTX-K9, electrical, or Ethernet card. The card view appears.
Note
In an ONS 15310-MA SDH node, the 15310E-CTX-K9 card provides optical ports and the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards provide electrical ports. The ONS 15310-MA
SDH supports Ethernet cards.
Step 2
Click the Performance tab.
Step 3 Click the E1, DS3, E3, or Optical tabs.
Note Different port and signal-type drop-down lists appear depending on the port type and the circuit
type. The appropriate types (E1, DS3, VC low-order path, VC high-order path, STM-M section,
and STM-M line) appear based on the card.
Step 4 Click the Port/Line drop-down list and highlight the desired port/line. (Options vary depending on the
port.)
Step 5
Click the signal type drop-down list and highlight the desired signal. (Options vary depending on the
port.)
Step 6 Click Refresh . All PM counts recorded by the near-end or far-end node appear for the specified outgoing
signal type on the selected card and port. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the
Cisco ONS 15310-MA SDH Reference Manual .
Step 7
View the Curr column to find PM counts for the current time interval.
Step 8 View the Prev- n columns to find PM counts for the previous time intervals.
Step 9
Return to your originating procedure (NTP).
Purpose This task enables you to monitor near-end or far-end PM counts for
specific signals on a selected card and port.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher