Chapter 2 Installation
Installing the CPE
2-16
Cisco LRE CPE Hardware Installation Guide
78-11469-04
Figure 2-3
Installing the Mounting Screws Under a Desk
Note
The template has adhesive to hold it in place while you drill holes
underneath the desktop. If you have purchased a 6- or 24-multipack, you
will be using the same screw template to install several CPEs. Do not use
the adhesive. Instead, hold the template against the bottom of the desk
while you drill the screw holes and insert the screws.
Step 4
(Optional) Peel the adhesive strip off the bottom of the screw template, and attach
it to the underside of the desk.
Step 5
Use a 0.144-inch (3.7-millimeters) or a #27 drill bit to drill 1/2-inch
(12.7-millimeters) holes in the two screw template slots.
Step 6
(Optional) If you wish to attach the cable lock after the cables are installed, drill
a 1/2-inch (12.7-millimeters) hole in the cable lock hole. For more information,
see the
“Attaching the Cable Lock” section on page 2-29
.
Step 7
Insert two screws in the slots on the screw template, and tighten until they touch
the top of the screw template.
Step 8
Remove the screw template from underneath the desk.
Step 9
Slide the CPE onto the mounting screws until it locks in place. (See
Figure 2-4
.)
3 in.
(7.6 cm)
Desktop
Screw template
Wall
Screw
Cable
lock hole
Adhesive
47502
at least
1/2 in.
(12.7 mm)
Screw
