18-17
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 18
Configuring Interfaces
Troubleshooting the Interface Configuration
Examples
The following example shows how to change the default ATM interface type to
private
using the
atm uni type private
command:
Switch#
configure terminal
Switch(config)#
interface atm 0/0/0
Switch(config-if)#
atm uni type private
The following example shows how to change the clock source using the
clock source network-derived
command:
Switch#
configure terminal
Switch(config)#
interface atm 0/0/0
Switch(config-if)#
clock source network-derived
See
Troubleshooting the Interface Configuration, page 18-17
to confirm your interface configuration.
Troubleshooting the Interface Configuration
Table 18-1
describes commands that you can use to confirm that the hardware, software, and interfaces
for the ATM switch router are configured as intended:
Table 18-1 Configuration Testing Commands
Command Purpose
show version
Confirms the correct version and type of software installed.
show hardware
Confirms the type of hardware installed in the system.
show interfaces
Confirms the type of hardware installed in the system.
show atm addresses
Confirms the correct configuration of the ATM address.
ping atm
Tests for connectivity between the switch and a host.
show
{
atm
|
ces
}
interface
Confirms the correct configuration of the ATM interfaces.
show atm status
Confirms the status of the ATM interfaces.
show atm vc
Confirms the status of ATM virtual interfaces.
show running-config
Confirms the correct configuration.
show startup-config
Confirms the correct configuration saved in NVRAM.
show controllers
{
atm
|
ethernet
} Confirms interface controller memory addressing.
