7-27
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 7
Configuring Virtual Connections
Configuring Soft PVP Connections
To configure a soft PVP connection, perform the following steps, beginning in global configuration
mode:
The row index for
rx-cttr
and
tx-cttr
must be configured before using this optional parameter. See the
Chapter 9, “Configuring Resource Management.”
.
Example
The following example shows how to configure a soft PVP on Switch B between interface ATM 0/0/2,
source VPI = 75; and Switch C, destination VPI = 75, with a specified ATM address (see
Figure 7-7
):
Switch-B(config)# interface atm 0/0/2
Switch-B(config-if)# atm soft-vp 75 dest-address
47.0091.8100.0000.0040.0b0a.2a81.4000.0c80.9010.00 75
Displaying Soft PVP Connections
To display the ATM soft PVP configuration, use the following EXEC command:
Examples
The following example shows the soft PVP configuration at Switch B, on interface ATM 0/0/2 out to the
ATM network:
Switch-B#
show atm vp
Interface VPI Type X-Interface X-VPI Status
ATM0/0/2 1 SVP ATM0/0/2 75 UP
ATM0/0/2 75 SoftVP ATM0/0/2 1 UP
Command
Purpose
Step 1
Switch(config)#
interface atm
card
/
subcard
/
port
Switch(config-if)#
Selects the interface to be configured.
Step 2
Switch(config-if)#
atm soft-vp
source-vpi
dest-address
atm-address dest-vpi
[
enable
|
disable
] [
upc
upc
] [
rx-cttr
index
] [
tx-cttr
index
]
[
retry-interval
[
first
interval
]
[
maximum
interval
]] [
redo-explicit
[
explicit-path
precedence
{
name
path-name
|
identifier
path-id
} [
upto
partial-entry-index
]]
[
only-explicit
]]
[
hold-priority
priority
]
[
timer-group
name]
Configures the soft PVP connection.
Command
Purpose
show atm vp
[
interface atm
card
/
subcard
/
port vpi
]
Shows the soft PVP configuration.