6-7
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 6
Configuring ATM Network Interfaces
Configuring IISP Interfaces
Configuring IISP Interfaces
The Interim Interswitch Signalling Protocol (IISP) defines a static routing protocol for use between ATM
switches. IISP provides support for switched virtual connections (SVCs) on switches that do not support
the Private Network-Network Interface (PNNI) protocol. For further information, see
Chapter 11,
“Configuring ATM Routing and PNNI.”
To configure an IISP interface, perform the following tasks, beginning in global configuration mode:
Example
The following example shows how to configure ATM interface 3/0/0 on the ATM switch router (SB-1)
as user side IISP and specifies an ATM route address prefix:
Switch(SB-1)(config)#
interface atm 3/0/0
Switch(SB-1)(config-if)#
no atm auto-configuration
Switch(SB-1)(config-if)#
%ATM-6-ILMINOAUTOCFG: ILMI(ATM3/0/0): Auto-configuration is disabled, current interface
parameters will be used at next interface restart.
Switch(SB-1)(config-if)#
atm iisp side user
Switch(SB-1)(config-if)#
%ATM-5-ATMSOFTSTART: Restarting ATM signalling and ILMI on ATM3/0/0.
Switch(SB-1)(config-if)#
exit
Switch(SB-1)(config)#
atm route
47.0091.8100.0000.0000.0ca7.ce01 atm 3/0/0
Command
Purpose
Step 1
Switch(config)#
interface atm
card
/
subcard
/
port
[
.
vpt#
]
Switch(config-if)#
Selects the interface to be configured.
Step 2
Switch(config-if)#
no atm auto-configuration
Disables autoconfiguration on the interface.
Step 3
Switch(config-if)#
atm iisp
[
side
{
network
|
user
}] [
version
{
3.0
|
3.1
|
4.0
}]
Configures the ATM IISP interface.
Step 4
Switch(config-if)#
exit
Switch(config)#
Exits interface configuration mode.
Step 5
Switch(config)#
atm route
addr-prefix
atm
card
/
subcard
/
port
[
.
subinterface#
]
Configures the ATM route address prefix.
