Cisco GoQAM, Installation And Operation Manual

Page: 54 / 178

Chapter 3 Provision the RF GoQAM
38 4004834 Rev D
Understand the RF GoQAM GUIs
This section provides examples and descriptions of the GUIs used for provisioning
the RF GoQAM as a DBDS network element in an Overlay environment.
Important!
Actual GUIs may differ slightly from the GUIs presented in this guide.
Understanding the RF GoQAM GUIs
Use the DNCS RF GoQAM GUIs to provision the RF GoQAM on the DNCS. The
main GUI is the Set Up RF GoQAM window. The Set Up RF GoQAM window
contains the following fields:

Basic Parameters

Advanced Parameters

Connectivity
Note: This section includes examples and descriptions of all of the areas within these
fields.
Understanding Basic Parameters
The Basic Parameters fields allow you to identify the GoQAM, assign it to a
headend, and specify the modulation type for each of the RF Out ports. If you want
to view the Basic Parameters fields while reading this section, follow these steps to
examine the Set Up RF GoQAM window.
1
From the DNCS Administrative Console, select one of the following tabs:

For SR 2.7/3.7/4.2 and later, click the Network Element Provisioning tab.

For SR 2.5/3.5/4.0 and earlier, click the Element Provisioning tab.
2 Click QAM . The QAM List window opens.