Cisco CIVS-IPC-2500, User Manual

Page: 35 / 90

3-13
Cisco Video Surveillance System IP Camera User Guide
OL-14220-02
Chapter 3 Configuring and Managing the IP Camera
Administration Windows
If you change any options in the IP Filter window, you must click Save to save the changes. To discard
the changes, click Cancel before clicking Save . These buttons appear at the bottom of the window. You
may need to scroll down to see them.
Table 3-5 describes the options in the IP Filter window.
Note These features are not currently supported if you use the IP camera with Cisco VSM.
Administration Windows
The Administration windows let you configure IP camera users, reset or restart the IP camera, and
upgrade firmware on the IP camera.
The following sections describe the Setup windows in detail:
•
Users Window, page 3-13 .
•
Maintenance Window, page 3-15
•
Firmware Window, page 3-16 .
Users Window
The Users window lets you configure access to the IP camera for the following types of users:
•
Administrator—Can access the configuration windows for the IP camera, view video in the Home
window, and access all controls in the Home window.
•
User—You can configure up to 20 users and assign privilege levels to each one.
Table 3-5 IP Filter Window Options
Option Description
Options Choose the option that specifies how to control IP addresses from which the
IP camera can be accessed:
•
Disable —Do not use the IP address filtering feature. In this case, the IP
camera can be accessed from a device with any IP address.
•
Enable and deny the following IP address —Lets you designate one or
more IP addresses or range of IP addresses that cannot access the IP
camera. All other IP addresses can access the IP camera.
• Enable and allow the following IP address —Lets you designate one
or more IP addresses or range of IP addresses that can access the IP
camera. All other IP addresses cannot access the IP camera.
Single/Range If you enable IP address filtering, choose either of the following options
from as many drop-down lists as needed:
•
Single —Enter an IP address that is denied or allowed access to the IP
camera, depending on the Options setting.
• Range —Enter a range of IP address that is denied or allowed access to
the IP camera, depending on the Options setting.