2-271
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
match (class-map configuration)
Note
Though visible in the command-line help strings, the
any
,
class-map
,
destination-address
,
not
,
protocol
, and
source-address
keywords are not supported.
Defaults
No match criteria are defined.
Command Modes
Class-map configuration
Command History
Usage Guidelines
Before entering the
match
command, you must first enter the
class-map
global configuration command
to specify the name of the class whose match criteria you want to establish. The
match
command is used
to specify which fields in the packets are examined to classify the packets. If a packet matches the
specified criteria, the packet is considered a member of the class and is forwarded according to the
quality of service (QoS) specifications set in the traffic policy.
For the
match
ip dscp
dscp-list
or the
match
ip precedence
ip-precedence-list
command, you can enter
a mnemonic name for a commonly used value. For example, you can enter the
match
ip dscp af11
command, which is the same as entering the
match
ip dscp 10
command. You can enter the
match
ip
precedence critical
command, which is the same as entering the
match
ip precedence 5
command. For
a list of supported mnemonics, enter the
match
ip dscp ?
or the
match
ip precedence ?
command to
see the command-line help strings.
You can configure the
match
cos
[
inner
]
cos-list
,
match ip dscp
dscp-list
,
match ip precedence
ip-precedence-list
,
match mpls experimental
exp-list
, or the
match vlan
command in a class map
within a policy map attached to an enhanced-services (ES) port. The
match
access-group
acl-index-or-name
command is not supported in an egress policy attached to an ES port or in a
hierarchical ingress policy attached to an ES port. You can configure only the
match access-group
acl-index-or-name
command and the
match input-interface
interface-id-list
command in a single-level
ingress policy map
attached to a standard port or to an ES port.
The
match cos
inner
cos-list
command has no effect on non-802.1Q tunneling traffic.
If you want to match the CoS of traffic received on an ES port that is in 802.1Q tunneling mode, use the
match cos
cos-list
command rather than the
match cos
inner
cos-list
command. The traffic is not tagged
twice at the time that the match takes place.
You cannot mix VLAN-level and class-level matches within a class map.
To configure a class map that matches an 802.1Q tunneling pair (instead of matching a single VLAN),
you must configure the
class-map
global configuration command with the
match-all
keyword. You must
enter the
match vlan
command before the
match vlan inner
command.
If you enter the
match vlan
or the
match vlan inner
command, the
class-map match-any
command is
not supported.
Use the
input-interface
interface-id-list
keyword when you are configuring an interface-level class map
in a hierarchical dual-level policy map. For the
interface-id-list
, you can specify up to six entries.
Release
Modification
12.1(14)AX
This command was introduced.
12.2(25)EY
The
inner
and the
input-interface
keywords were added.
