2-527
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show lacp
This is an example of output from the
show lacp internal
command:
Switch>
show lacp 1 internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 1
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Fa1/0/5 SA bndl 32768 0x3 0x3 0x4 0x3D
Fa1/0/6 SA bndl 32768 0x3 0x3 0x5 0x3D
Fa1/0/7 SA bndl 32768 0x3 0x3 0x6 0x3D
describes the fields in the display:
Table 2-24
show lacp counters Field Descriptions
Field
Description
LACPDUs Sent and Recv
The number of LACP packets sent and received by an interface.
Marker Sent and Recv
The number of LACP marker packets sent and received by an
interface.
Marker Response Sent and Recv
The number of LACP marker response packets sent and received
by an interface.
LACPDUs Pkts and Err
The number of unknown and illegal packets received by LACP
for an interface.
Table 2-25
show lacp internal Field Descriptions
Field
Description
State
State of the specific port. These are the allowed values:
•
– —Port is in an unknown state.
•
bndl
—Port is attached to an aggregator and bundled with
other ports.
•
susp
—Port is in a suspended state; it is not attached to any
aggregator.
•
hot-sby
—Port is in a hot-standby state.
•
indiv—
Port is incapable of bundling with any other port.
•
indep
—Port is in an independent state (not bundled but able
to switch data traffic. In this case, LACP is not running on
the partner port).
•
down
—Port is down.
LACP Port Priority
Port priority setting. LACP uses the port priority to put ports s
in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
