2-5
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
action
action
Use the
action
access map configuration command to set the action for the VLAN access map entry. Use
the
no
form of this command to set the action to the default value, which is to forward.
action
{
drop
|
forward
}
no action
Syntax Description
Defaults
The default action is to forward packets.
Command Modes
Access-map configuration
Command History
Usage Guidelines
You enter access-map configuration mode by using the
global configuration command.
If the action is
drop
, you should define the access map, including configuring any access control list
(ACL) names in match clauses, before applying the map to a VLAN, or all packets could be dropped.
In access map configuration mode, use the
match
access map configuration command to define the
match conditions for a VLAN map. Use the
action
command to set the action that occurs when a packet
matches the conditions.
The drop and forward parameters are not used in the
no
form of the command.
Examples
This example shows how to identify and apply a VLAN access map
vmap4
to VLANs 5 and 6 that causes
the VLAN to forward an IP packet if the packet matches the conditions defined in access list
al2
:
Switch(config)#
vlan access-map vmap4
Switch(config-access-map)#
match ip address al2
Switch(config-access-map)#
action forward
Switch(config-access-map)#
exit
Switch(config)#
vlan filter vmap4 vlan-list 5-6
You can verify your settings by entering the
show vlan access-map
privileged EXEC command.
drop
Drop the packet when the specified conditions are matched.
forward
Forward the packet when the specified conditions are matched.
Release
Modification
12.1(14)AX
This command was introduced.
