Cisco 7940G, Administration Manual

Page: 175 / 184

D-17
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
OL-7890-01
Appendix D SIP IP Phone Parameters
xml_card_dir Reserved.
xml_card_file Reserved.
Table D-1 Configuration File Parameters (continued)
Parameter Description
Table D-2 Network Parameters
Parameter Description
Admin.VLAN Id Unique identifier of the VLAN to which the phone
is attached, for use in switched networks that are
not Cisco networks.
Note
If you have an administrative VLAN
setting assigned on the Catalyst switch,
that setting overrides any changes made
on the phone.
Alternate TFTP Whether to use an alternate remote TFTP server
rather than the local one.
Valid values are Yes and No. If you set this
parameter to Yes, you must change the IP address
in the TFTP Server parameter to the address of the
alternate TFTP server. Default is No.
Default Router 1 to 5 IP address (1) of the default gateway used by the
phone and (2 to 5) of the gateways that the phone
attempts to use as an alternate gateway if the
default gateway is unavailable.
Note Default Router 1 always takes
precedence. If Router 1 is unavailable, the
phone moves down the list of available
routers in order based on the configuration
in Routers 2 through 5.
Note If you have an administrative VLAN
setting assigned on the Catalyst switch,
that setting overrides any changes made
on the phone.
DHCP Address Released Whether the IP address of the phone can be
released for reuse in the network.
Valid values are Yes and No. When set to Yes, the
phone sends a DHCP release message to the
DHCP server and goes into a release state. The
release state provides enough time to remove the
phone from the network before the phone attempts
to acquire another IP address from the DHCP
server. When you move the phone to a new
network segment, first release the DHCP address.