5-4
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
Chapter 5 Maintaining Your Cisco 7505 Router
Maintenance Procedures for the Cisco 7505
Use the following procedure to remove the chassis cover panel:
Figure 5-1
Removing and Replacing the Cisco 7505 Cover Panel
Step 1
Use a 3/16-inch flat-blade screwdriver to loosen the two captive screws on the front of the cover panel.
Step 2
Pull the top of the panel out about 3 inches (7.62 cm); then grasp the sides of the panel and pull it upward
and away from the chassis.
Note
See the appropriate sections depending on the replacement procedures you need to perform. Then, to
replace the chassis cover panel, proceed to the following procedure.
Use the following procedure to replace the chassis cover panel:
Step 1
Hold the sides of the cover panel with both hands and tilt the top of the panel back slightly (toward you).
(See
Figure 5-1
.)
Step 2
Slide the guide tabs into the slots in the bottom edge of the chassis.
Step 3
Using the guides as a pivot point, push the top half of the panel back toward the chassis opening until
the panel is flush with the edges of the chassis.
Step 4
Hold the top front of the panel in place, if necessary, while you tighten the two captive screws with a
3/16-inch flat-blade screwdriver.
This completes the chassis cover panel removal and replacement procedure.
H2869
Captive screws
