15-23
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
78-16527-01
Chapter 15 Configuring IDSM-2
Configuring EtherChanneling
Step 4
To remove the whole EtherChannel:
Note
The VACL capture commands for IDSM-2 will be left.
router(config)#
no intrusion-detection module
port-channel
channel_number
Verifying EtherChanneling
To verify the IDSM-2 EtherChannel configuration, follow these steps:
Step 1
Log in to the console.
Step 2
To see all EtherChannels:
router#
show etherchannel
Channel-group listing:
-----------------------
Group: 10
----------
Group state = L2
Ports: 0 Maxports = 8
Port-channels: 1 Max Port-channels = 1
Protocol: -
cat6k#
Step 3
To see specific EtherChannel status:
router#
show etherchannel 1
[
summary | detail | port | port-channel | protocol
]
Example:
router#
show etherchannel 1 summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
u - unsuitable for bundling
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----------+----------------------------
router#
Step 4
To see the EtherChannel load balance setting:
router#
show etherchannel load-balance
EtherChannel Load-Balancing Configuration:
src-dst-ip
mpls label-ip
