3-26
P/N 11934-003
Section 3
Cirrus Design
Emergency Procedures
SR20
• WARNING •
Aircraft equipped with Software Version 530-00123-000 Rev
00 or higher;
Any power interruption to the PFD will result in
loss of attitude information until the PFD can be restarted on
the ground.
Aircraft equipped with Software Version 530-00159-000 Rev
00 or higher;
When subjected to a power loss of less than 20
seconds, the PFD is capable of performing a warm start. In
this event, a “PLEASE STANDBY” message will be displayed
for 2 seconds followed by a “ATTEMPTING QUICK
RESTART” message. In the event of a power loss greater
than 20 seconds, a warm start is unlikely, and the power
interruption will result in loss of attitude information until the
PFD can be restarted on the ground.
Power Lever Linkage Failure
If the Power Lever linkage fails in flight, the engine will not respond to
power lever control movements. Use power available and flaps as
required to safely land the airplane.
If the power lever is stuck at or near the full power position, proceed to
a suitable airfield. Fly a forced landing pattern. With landing assured,
shut down engine by moving mixture control full aft to CUTOFF. If
power is needed again, return mixture control to full RICH and regain
safe pattern parameters or go-around. If airspeed cannot be
controlled, shut engine down and perform the
Forced Landing
checklist. After landing, bring the airplane to a stop and complete the
Emergency Engine Shutdown on Ground
checklist.
If the power lever is stuck at or near the idle position and straight and
level flight cannot be maintained, establish glide to a suitable landing
surface. Fly a forced landing pattern.
1. Power Lever Movement..................................................... VERIFY
2. Power ............................................................................ SET if able
3. Flaps ........................................................................ SET if needed
4. Mixture ..................................... AS REQUIRED (full rich to cut-off)
5. Land as soon as possible.
6.
Revision A5
Summary of Contents for SR20
Page 10: ...1 2 P N 11934 003 Section 1 Cirrus Design General SR20 Intentionally Left Blank Revision A3 ...
Page 22: ...2 2 P N 11934 003 Section 2 Cirrus Design Limitations SR20 Placards 2 21 Revision A6 ...
Page 308: ...9 2 P N 11934 003 Section 9 Cirrus Design Supplements SR20 Intentionally Left Blank Reissue A ...