P/N 11934-003
3-21
Cirrus Design
Section 3
SR20
Emergency Procedures
The maximum demonstrated deployment speed is 135 KIAS.
Reducing airspeed allows minimum parachute loads and prevents
structural overload and possible parachute failure.
2. Mixture (If time and altitude permit) ..................................CUTOFF
Generally, a distressed airplane will be safer for its occupants if
the engine is not running.
3. Activation Handle Cover...................................................REMOVE
The cover has a handle located at the forward edge. Pull cover
down to expose activation T-handle.
4. Activation Handle (Both Hands).............PULL STRAIGHT DOWN
Pull the activation T-handle from its holder. Clasp both hands
around the handle and pull straight down in a strong, steady, and
continuous motion. Maintain maximum pull force until the rocket
activates. Pull forces up to, or exceeding, 45 pounds may be
required. Bending of the handle-housing mount is to be expected.
• WARNING •
Jerking or rapidly pulling the activation T-handle will greatly
increase the pull forces required to activate the rocket. Use a
firm and steady pulling motion – a “chin-up” type pull
enhances successful activation.
After Deployment:
5. Mixture ............................................................... CHECK, CUTOFF
6. Fuel Selector............................................................................ OFF
Shutting off fuel supply to engine will reduce the chances of fire
resulting from impact at touchdown.
7. Bat-Alt Master Switches........................................................... OFF
8. Ignition Switch.......................................................................... OFF
9. Fuel Pump ............................................................................... OFF
10. ELT.............................................................................................ON
11. Seat Belts and Harnesses .............................................. TIGHTEN
(Continued on following page)
Revision A5
Summary of Contents for SR20
Page 10: ...1 2 P N 11934 003 Section 1 Cirrus Design General SR20 Intentionally Left Blank Revision A3 ...
Page 22: ...2 2 P N 11934 003 Section 2 Cirrus Design Limitations SR20 Placards 2 21 Revision A6 ...
Page 308: ...9 2 P N 11934 003 Section 9 Cirrus Design Supplements SR20 Intentionally Left Blank Reissue A ...