7-98
P/N 11934-003
Section 7
Cirrus Design
Airplane Description
SR20
2.
Press Control to activate count-up timer. Elapsed time counts up
to 59 minutes, 59 seconds, and then switches to hours and
minutes. Pressing the Control button again will reset the timer to
zero.
To set the count-down mode:
1.
Select ET using the Select button;
2.
Input a ‘count-down’ time using the same technique as setting UT
or LT (a maximum of 59 minutes, 59 seconds may be entered);
3.
Press the Select button to exit the set mode; and
4.
Press Control to start the count down. At zero, the alarm activates
and the display flashes. Pressing either Select or Control
deactivates the alarm.
Test Mode:
To enter the self-test mode, hold the Select button for 3 seconds. The
display will indicate “88:88” and all four (UT, LT, FT, ET) annunciators
will come on.
OAT – VOLTS Button
Serials 1268 through 1337;
The red OAT-VOLTS button is used to
display Outside Air Temperature and airplane Main Bus voltage.
When the airplane is powered down, the upper display will display the
clock’s back-up battery voltage. Upon power up, the display will show
the airplane’s Main Bus voltage. Pressing the button displays OAT in
°
F. Pressing the button again displays OAT in
°
C.
Serials 1337 and subsequent with Avionics Configuration PFD;
Outside Air Temperature annunciation is integrated into the MFD or
PFD.
Revision A5
Summary of Contents for SR20
Page 10: ...1 2 P N 11934 003 Section 1 Cirrus Design General SR20 Intentionally Left Blank Revision A3 ...
Page 22: ...2 2 P N 11934 003 Section 2 Cirrus Design Limitations SR20 Placards 2 21 Revision A6 ...
Page 308: ...9 2 P N 11934 003 Section 9 Cirrus Design Supplements SR20 Intentionally Left Blank Reissue A ...