Programming the hysteresis value
The hysteresis value, i.e., difference between the alarm connection and
disconnection value, in %, is programmed on this screen.
Press key
for 3 seconds to edit the hysteresis value selection. The
prog
icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing
the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to
modify the other values.
If you press the
key after changing the last digit, it will jump back to the first digit so you can
modify the previously programmed values again.
To validate the data, press
for 3 seconds and the
prog
icon will disappear from the display.
Press key
to access the next programming step.
Programming the latch
The interlocking is selected on this screen, i.e., if the alarm is
interlocked after it has been tripped, even when the condition that
triggered it has disappeared.
Press key
for 3 seconds to edit the selection. The
prog
icon will
be displayed on the bottom of the screen.
Press key
to browse the two options (Yes and No).
To validate the data, press
for 3 seconds and the
prog
icon will disappear from the display.
Press key
to access the next programming step.
Note:
If the device is reset, the status of alarms is deleted and all alarms will return to the programmed
standby status, provided that the condition that triggered them has been resolved.
Programming the time delay 2
The alarm disconnection delay is programmed on this screen in
seconds.
Press key
for 3 seconds to edit the maximum value selection. The
prog
icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing
the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to
modify the other values.
62
CVM-C10
Instruction Manual
