CipherLab CP30 Series, Reference Manual

Page: 113 / 187

101
Chapter 7 Using Reader Configuration Utility
7.2 BARCODE READER SETTINGS
The barcode reader configurations depend on the scan engine(s) installed. You can detect
which barcode type for scan currently in use and make necessary settings on the General
tab.
Barcode Reader Description
Laser Reader If installed, tap the [Barcode Reader] button to configure the reader
settings for CCD or Laser scan engine.

Refer to the Reader Settings Table in Appendix II - Laser (SE955).
2D Reader The 2D scan engine is capable of reading linear and 2D barcodes.
If installed, tap the [Barcode Reader] button to configure the reader
settings for 2D scan engine.

Refer to the Reader Settings Table in Appendix III - 2D Imager.
Decode Session Timeout The value (from 1 to 9 sec) sets the maximum time decode processing
continues during a decode attempt. The default value is 3 sec.
Redundancy Level Refer to Appendix II - Laser (SE955).
Scan Angle Select the scan angle for Long Range Laser scan engine.
Scan mode Supports Continuous and Laser Modes for selection.
Timeout between symbols Only available for Continuous mode. The default value is 1 sec.