CipherLab CP30 Series, Reference Manual

Page: 173 / 187

161
READER SETTINGS TABLE
The tables below list reader settings as well as symbology settings for the 2D scan
engine.
2D Engine Description Default
Decode Time-out Set the maximum time for decoding to continue during a
scan attempt.
 1~9 (second)
3 sec.
Decode Illumination Decide whether to flash illumination on every barcode
capture to aid decoding.
 Turn On (Internal LED )
 Turn Off
On
Aiming Pattern Decide whether to project the aiming pattern during
barcode capture.
 Turn On
 Turn Off
On
Redundancy Level Level 1
Level 1 The following barcodes must be successfully read twice before being
decoded:
Barcode Types Code Length
Codabar 8 characters or less
MSI 4 characters or less
Industrial 25 (Discrete 25) 8 characters or less
Interleaved 25 8 characters or less
Level 2 All barcodes must be successfully read twice before being decoded.
Level 3 All barcodes except for the following barcodes must be successfully read
twice before being decoded.
The following barcodes must be read three times:
Barcode Types “Excluded” Code Length
Codabar 8 characters or less
MSI 4 characters or less
Industrial 25 (Discrete 25) 8 characters or less
Interleaved 25 8 characters or less
Appendix III
2D IMAGER (SE4500)