CipherLab CP30 Series, Reference Manual

Page: 161 / 187

149
The tables below list reader settings as well as symbology settings for the Laser (SE955)
scan engine.
READER SETTINGS TABLE
Laser Engine Description Default
Decode Time-out Set the maximum time for decoding to continue during a
scan attempt.
 1~9 (second)
 3 sec.
Redundancy Level Level 1
Level 1 Following barcodes must be successfully read twice before being decoded:
Barcode Types Code Length
Codabar All
MSI 4 characters or less
Industrial 25 (Discrete 25) 8 characters or less
Interleaved 25 8 characters or less
Level 2 All barcodes must be successfully read twice before being decoded.
Level 3 All barcodes except for the following barcodes must be successfully read
twice before being decoded. Following barcodes must be read three times:
Barcode Types “Excluded” Code Length
MSI 4 characters or less
Industrial 25 (Discrete 25) 8 characters or less
Interleaved 25 8 characters or less
Level 4

All barcodes must be successfully read three times before being
decoded.
Scan Angle Select the scan angle for Long Range Laser scan engine.
 “narrow” for 35°
 “wide” for 47°
Wide
Scan Mode Laser mode
Continuous Mode Non-stop scanning
 To decode the same barcode repeatedly, move away the scan beam
and target it at the barcode for each scanning.
Appendix II
LASER (SE955)