Ciena LE-310, Installation Manual

Page: 46 / 94

36
LE-3xx/LE-4xx Hardware Installation & User Guide
I
NITIAL
C
ONFIGURATION
Do not remove the dust cover until immediately prior to mating the connectors. For best results,
prior to mating the Fiber optic connectors clean both the port and the connector with a lint free
cloth moistened with alcohol. If available, the connectors should also be blown dry using
canned, compressed air. Insert the connector into the port on the device until you hear a
clicking sound.
10/100 Mbps Ethernet Transmit and Receive Pairs
10BASE-T/100BASE-TX Ethernet uses four wires to communicate, leaving four wires unused.
However, all four pairs should be terminated. While Cat 5 cable is sufficient, Ciena/World Wide
Packets recommends using Category 5e+ cable or better. All Ethernet cables must be shielded
to meet the class B radiated emissions requirements.
Initial Configuration
Two different methods can be used to assign an IP address to the device. The recommended
method is for the device to receive its IP address and other information automatically using a
DHCP server. Alternately, an IP address can be configured manually using the CLI. If additional
information on configuring an IP address is needed, contact Customer Support.
NOTE: If the device has not been assigned an IP address other than the default
IP address (either manually or through a DHCP server) communication can only
take place through the local management port. Initial IP address configuration
must therefore be done through the local management port.
CAUTION:
Use caution when setting an IP address or subnet mask, the new value
takes effect immediately. If information is set that is inconsistent with network
settings, communication with the device may no longer be possible. If all other
troubleshooting methods have been exhausted, recovery may be possible using
the Reset button.
VORSICHT: Bei der Einrichtung einer IP-Adresse oder Subnetzmaske achtsam
sein, denn der neue Wert wird sofort wirksam. Wenn eine mit den
Netzwerkeinstellungen unvereinbare Adresse eingerichtet wird, ist mit dem Gerät
keine Kommunikation mehr möglich. Falls alle Fehlerbehebungsmethoden
erfolglos waren, kann die Wiederherstellung eventuell mit der Reset-Taste
erreicht werden.
ATTENTION:
La définition de l'adresse IP ou du masque de sous-réseau exige une
précaution particulière dans la mesure où les nouvelles valeurs prennent effet
imm
édiatement
. Si les valeurs saisies ne correspondent pas aux paramètres du