9
Installation
1
2
3
4
5
6
7
8
9
10
11
Install the product on a level surface. (Change product level as needed using
the product leg adjustment).
-
rarily remove the connector part as provided from your given water source.
Then connect the main water line adaptor.
If the sealing O-ring at the connection piece is removed or damaged, it can lead to
leakage.
Connect tubing hose into water source adaptor and then attach to the water
inlet on the rear side of product.
-
tion of the product.
Connect tubing hose into the removed water(brine) and drained water con-
nection part on the rear side of product and then connect tubing hose into the
drainage hole in sink, bathroom, or multi-purpose room, etc.
Install the removed water (brine) line and drained water line separately. If
drainage does not function properly due to improper installation, then water
may flow back towards the waterspout and cause an overflow.
Adjust the tubing hoses of the discharged water (brine) and tap water tubing
hose so that water does not splash into the surrounding areas.
Open the tap water valve supplied into each household, and place the water
source adaptor to the open position.
Check to see if water is leaking at each connection part.
For stabilization of the cooling system and for safe use of this product, insert
the power plug into an AC 110V60Hz, 220V50Hz, 240V/50Hz and 220V/60Hz
power outlet 30 minutes after installing the product.
Check to see whether water is being supplied to the inside of the product and
whether there is any leakage in or around the tubing connections.
Check whether water is coming out by pressing the water dispensing button 1
9
17
