3.
2.
7
8
①
②
Press
, one beep is heard and the LED indicator is on.
Keypad enters the learning state.
[9]
Put RFID tag close to the RFID reader, the connection
succeeds after one beep and the LED indicator goes out.
If two beeps are heard, it indicates the RFID tag has been connected before.
To clear the connection of RFID tags, input
to wake up the
keypad and then press down
for six seconds. RFID tags are all cleared after
one beep.
[admin code + #]
[9]
Connect Electronic Door Lock
To know connection steps, please refer to the instruction
manual of electronic door lock.
Installation
Fix the keypad on the door frame or the wall before use.
Loose the screw, open the case
Fix the rear cover on the door frame or the wall by screws
③
④
Fasten the front cover of keypad on the rear cover. Secure two
covers into place
Screw on
Note!
Opening the rear cover of keypad will trigger tamper switch,
please disarm the alarm by following the disarm instruction in page 20.
