Input
to wake up keypad.
[admin code + #]
9
10
Settings
The keypad should enter setup state before all settings.
Enter Setup State
Press
to enter setup state, the LED indicator is on.
[3]
Under setup state, if there is no operation within 10 seconds, the keypad will
exit setup state automatically. You can also press
to exit.
[#]
Default admin code: 123456
Delay Arm
When the alarm system is armed, detectors will start working
immediately. At that time, if you still stay at home, it will
trigger an alarm. After setting delay arm, press
on the
keypad, the arm signal will be sent to the control panel after
the set time.
[Arm]
This setting does not apply to Stay Mode.
If both control panel and keypad are set delay time respectively, the actual
delay time is the total of both times.
Delay Arm
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Once the delay time is set, when you arm the keypad, it will beep once
every two seconds to remind you to leave. The reminding rhythm will
speed up in the last 15 seconds. After the delay time, the control panel
enters arm state.
Note!
User can input digital 0-250 which refers to 0-250 seconds.
Default setting: 0, no delay.
2
delay time
