2. Loosen the three captive screws securing the cover.
3. Lift the cover up and out to remove.
4. To re-install, align the bottom tabs and follow these steps in reverse order.
Removing the rear cover
The rear cover provides access to the lamp adjuster, the ceramic douser plate, and other components.
Estimated replacement time: 2 minutes
1. Shut down the projector (on page 22).
2. Remove the touch panel controller (on page 39).
3. Loosen the three screws securing the back.
4. Tilt and lift the back cover slightly for the bottom tabs to clear the frame and remove.
5. To re-install, align the bottom tabs and follow these steps in reverse order.
Removing the front cover
The front cover
Estimated replacement time: 35 m 10 minute calibration
1. Remove the front top cover (on page 40).
2. Remove the light engine cover (on page 41).
3. Remove the front lamp-side cover (on page 42).
4. Remove the front lens-side cover (on page 43).
5. Remove the projection lens (on page 79).
6. Remove the front cover of the projector:
Parts and module replacement
Roadie 4K35 and 4K45 Service Manual
44
020-101694-03 Rev. 1 (01-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.
