Make sure the concrete anchors do not pull away from the concrete when tightening the
screws.
9. Tighten the four #14 x 2.5" wood screws so that the wall plate is firmly attached, but do not
over-tighten.
Never tighten in excess of 80 in-lbs (9Nm).
Attaching the adapter brackets to the display
panel
The display panel must have the adapter brackets installed before it can be attached to the wall
mount.
If the VESA extenders are required, install them onto the brackets before attaching the brackets to the
panel.
1. Remove the handles from the panel.
2. When installing the brackets on the UHD654-X-HR display panel, remove the pull handle from
the top of the bracket, and replace it with the longer pull handle (M).
3. Attach the adapter brackets to the back of the display panel using eight M8 x 15 mm socket
pin screws.
For 49" display panels, the spacers can be used but the installed display panel will be more
than 4" from the wall.
For 55" and 65" display panels, insert the spacer between the adapter brackets and the display
panel before attaching the brackets with the M8 socket pin screws.
Installing flat panels on the ML25 wall mount
Installing Flat Panels on the ML25 Wall Mount Instruction Sheet
8
020-001812-01 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
