Maintain an upright position of the panel when installing on the wall mount. Tilting the panel
greater than 10 degrees may result in damage.
5. Adjust the x-axis location of the panel by sliding the panel along the tip cross bar to achieve
desired location and then lock adjustment.
6. Adjust the y-axis location of the panel by turning the adjustment wheels to achieve the desired
location and then lock adjustment.
7. Adjust the z-axis location of the panel by adjustment screw to achieve the desired location.
8. Loosely fasten the panel in place using the security screw.
9. Install the AC or CD power cables and the signal loop through cables.
Use the cable routing channel on the right-hand side of the mount or route the cables along
the top and bottom of the mount to utilize the holes for cable tie attachments. Cable routing
channels are also available on the LCD panel.
10. Repeat steps 1 to 9 for each panel in the video wall.
11. Before installing the row above, use a 4mm pin hex wrench to tighten the security screws on
the bottom of each mount to lock the panels in place.
Moving the display panel left and right
Slide the panel to the left or right to align it with the panel to the side.
1. Using a 4mm pin hex wrench, loosen the security screws holding the panel adapter brackets
onto the wall mount.
2. Slide the panel to the left or right as necessary.
3. Tighten the security screws.
Installing flat panels on the ML25 wall mount
Installing Flat Panels on the ML25 Wall Mount Instruction Sheet
10
020-001812-01 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
