Required tools
Ensure the appropriate tools are available during the installation.
•
4mm pin hex wrench
•
Pencil
•
Drill
•
Phillips screwdriver
•
#1 and #3 Philips drill bit
•
9/32" socket and socket wrench
•
5/16” (8 mm) bit for concrete and cinder block walls
•
5/32” (4 mm) bit for wood stud walls
•
Level
•
Tape measure
•
Hammer
Ventilation requirements
For adequate ventilation, ensure the array does not exceed the maximum number of rows, as
described in the table below.
The recommendation is based on the ambient temperature of the installation and an 8mm gap
between the wall and the LCD display panels.
Notice. If not avoided, the following could result in property damage.
•
Always provide proper ventilation for the product to prevent overheating.
The following ventilation requirements are available for FHD493-XE, FHD553-XE,FHD553-X, FHD553-
XE-R, FHD553-XE-H, FHD553-XE-HR, FHD554-XZ-H.
Ambient temperature
Maximum number of rows
25 °C (77 °F)
6
30 °C (86 °F)
5
35 °C (95 °F)
5
The following ventilation requirements are available for UHD654-X-HR and FDH554-XZ-H.
Ambient temperature
Maximum number of rows
25 °C (77 °F)
4
30 °C (86 °F)
4
35 °C (95 °F)
3
40 °C (104 °F)
2
The following ventilation requirements are available for FDH554-XZ-HR.
Installing flat panels on the ML25 wall mount
Installing Flat Panels on the ML25 Wall Mount Instruction Sheet
4
020-001812-01 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
