Safety warnings and cautions
To prevent personal injury and to protect the device from damage, read and follow these safety
precautions.
Warning! If not avoided, the following could result in death or serious injury.
•
Concrete wall must be at least 8" (203 mm) thick with a minimum of 2000 psi density. Lighter
density concrete may not hold the concrete anchor.
•
Cinder block wall must meet ASTM C-90 specifications and have a minimum nominal width of 8
in (203 mm).
•
Wood studs covered with plywood must be a minimum of 2 in x 4 in nominal size and the
plywood a minimum ½ in (13 mm) thick. Plywood may be covered by drywall up to 5/8 in
(15.875 mm) thick.
•
The supporting structure must safely support the combined load of the product, all attached
hardware, and components following all local safety standards and regulations.
•
A minimum of two people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Always handle the display panel from the sides or handles.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
Before drilling holes locate electrical, gas, and water lines.
•
Only install the product on recommended surfaces.
Caution! If not avoided, the following could result in minor or moderate injury.
•
PINCH HAZARD! Keep fingers away when operating the mount.
•
Do not over-tighten hardware.
•
This product is intended for indoor use only.
•
Do not exceed the maximum load capacity of the product.
•
Always provide proper ventilation for the product to prevent overheating.
•
Before installation, inspect all components for cracks, deformations, corrosion, and missing or
damaged parts that could reduce their installation strength.
Handling and mounting guidelines
Follow these best practices when handling and mounting panels.
Notice. If not avoided, the following could result in property damage.
•
When moving the panel, always use the handles. Do not carry the panel by the frame.
•
Do not twist, bend, or tilt the panel.
•
Do not apply excessive force to the sides of the bezel when mounting the panel or pushing into
its locked position.
•
Always handle the display panel from the sides or handles.
Follow the following guidelines before removing the panel from the packaging.
•
Always use the handles to pick up and carry the panel.
•
Leave the panel in the box until the mount is on the wall and you are ready to install the panel.
Installing flat panels on the ML25 wall mount
Installing Flat Panels on the ML25 Wall Mount Instruction Sheet
2
020-001812-01 Rev. 1 (04-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
