Operation
Mirage WQ-L User Manual
49
020-101372-01 Rev. 1 (04-2014)
Actual Frame Delay
This control indicates the dynamically calculated, effective minimum frame delay for the projector.
Power Management
To access the Power Management menu select Configuration > Power Management from the
main menu.
Auto Power Up
If there is an AC power interruption while Auto Power Up is enabled, the projector will resume
operation in the same state as it left off. If the light engine is On and an image showing when AC
power is lost, the projector will automatically power back up, and an image will show when AC is
restored.
Auto Shutdown Enable
When Auto Shutdown Enable has been selected, and no projector activity has been seen for the
activation time-out period, the projector will enter a power-saving mode in which the light engine
will dim and the shutter will close. If this condition persists for an additional time-out period, the
projector will automatically go into Standby mode. The presence of any activity within this
combined interval will cancel auto shutdown and return the projector to normal operation.
Turn Off Image After (min)
This sets the activation interval (in minutes) for auto shutdown. If all activity (input signals, Web or
Serial port activity key presses) is lost for this length of time, and auto shutdown is enabled, an
auto shutdown cycle will begin.
Enter Standby After (min)
This sets the interval (in minutes) between starting Auto Shutdown and entering Standby mode.
Once Auto Shutdown has been entered, and all activity continues to be absent for this interval, the
projector will automatically enter power Standby mode.
Stealth Mode
Check this option to operate the projector with the status LED display on the input panel powered
Off. The status LED is powered Off during operation only. In Standby mode, the status LED displays
codes normally. Operating in Stealth mode is recommended when images are displayed using only
non-visible (IR) light. In this mode any visible light from the projector can noticeably reduce image
contrast as seen through NVG devices.
Fan Assist
If necessary, use the slide bar to increase projector fan control. An increase to this setting will make
the fans quicker to react and run at a higher intensity. The default setting is 0. Increase the setting
when operating in high ambient conditions. This may help ease thermal problems in such
environments. Fan assist increases noise levels.
Change Date and Time
To change the current year-month-day, hour-minute-second go to Configuration > Date and
Time. Changes made reset the projector real-time clock.
