Christie J Series, Setup Manual

Page: 9 / 60

Section 1: Introduction
J Series 2.0, 2.4, and 3.0kW Setup Guide 1-3
020-100751-01 Rev. 1 (10-2011)
1.2 Safety Warnings and Guidelines
1.2.1 General Precautions
HIGH BRIGHTNESS. Never look directly into the projector lens. The extreme high
brightness can cause permanent eye damage.
Always power down the projector and disconnect all power sources before servicing
or cleaning.
FIRE HAZARD. Keep hands, clothes and all combustible material away from the
concentrated light beam of the projector. Position all cables where they cannot
contact hot surfaces or be pulled or tripped over.
WARNING
All installation and maintenance procedures must be performed by a Christie
accredited service technician.
WARNING
Projector must be operated in an environment that meets operating specifications, as
listed in 7 Specifications .
1.2.2 AC /Power Precautions
WARNING
Use only the AC power cord supplied. Do not attempt operation if the AC supply and
cord are not within the specified voltage and power range. Refer to the license label
on the back of the projector or
7 Specifications for rated voltage and power.
WARNING
The projector is equipped with a 3-wire plug with a grounding pin. This is a safety
feature. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. NEVER defeat the safety purpose of the grounding-type
plug.
WARNING
Do not allow anything to rest on the power cord. Locate the power cord where
persons walking on it or objects rolling over it cannot damage the cord.