J Series 2.0, 2.4, and 3.0 kW Setup Guide
4-1
020-100751-01 Rev. 1 (10-2011)
4 Maintenance
4.1
Lamp and Filter Replacement
Lamp
Do not operate the lamp for more than the warranty limit; risk of the lamp shattering increases as a result of
changes in the quartz glass that occur with use. Operation beyond the lamp warranty limit also significantly
reduces brightness output.
Wait approximately 5 minutes after powering down the projector to allow the lamp to
cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use. The lamp is under great
pressure when hot and may explode, causing personal injury and/or property damage.
Use only lamps supplied by Christie.
Lamp Replacement Procedure
Select the correct wattage lamp supplied by Christie. See
Table 4.1
. Read the lamp
replacement procedure in its entirety before proceeding.
A Christie accredited service technician must perform lamp replacement.
Cool the lamp completely, then lift the lamp by the handle only.
Do not touch the glass window of the lamp. Fingerprints left on the surface can lead to
an intense accumulation of heat called a “hotspot,” which could potentially result in
lamp failure. It is recommended you wear a face shield when working with the lamp.
For this procedure you will need the appropriate Lamp and Filter Kit manufactured by Christie Digital
Systems. See
Table 4.1
.
Table 4.1
Projector Part Number
Projector Model
Lamp Type
Lamp/Filter Kit Required
Roadster S+14K-J
132-010113-xx
2.0 kW
003-120135-xx
Mirage S+14K-J
132-010124-xx
Roadster HD14K-J
132-011114-xx
Mirage HD14K-J
132-011125-xx
Mirage WU14K-J
132-012126-xx
Matrix WU14K-J
132-012137-xx
Summary of Contents for J Series
