Christie J Series, Setup Manual

Page: 7 / 60

J Series 2.0, 2.4, and 3.0kW Setup Guide 1-1
020-100751-01 Rev. 1 (10-2011)
1 Introduction
Every effort has been made to ensure the information in this document is accurate and reliable; however, due to
constant research the information in this document is subject to change without notice.
1.1 Purchase Record and Service Contacts
Whether the projector is under warranty or the warranty has expired, Christie highly trained and extensive
factory and dealer service network is always available to quickly diagnose and correct projector malfunctions.
Complete service manuals and updates are available for all projectors. Should a problem be encountered with
any part of the projector, contact your dealer. In most cases, servicing is performed on site. If you have
purchased the projector, fill out the information below and keep with your records.
Table 1.1
Dealer:
Dealer or Christie Sales/Service Contact Phone Number:
Projector Serial Number*:
Purchase Date:
Installation Date:
* The serial number can be found on the license label located on the back of the projector.
Table 1.2 Ethernet Settings
Default Gateway:
DNS Server:
Projector DLP Address:
Projector Mgmt IP Address:
Subnet Mask:
1.1.1 List of Components
Ensure the following components were received with the projector:
ˆ
Projector with Built-In Keypad (LCD status display)
ˆ
IR remote keypad (includes two, 1.5V AA batteries and an XLR to mini-stereo cable conversion to wired)
ˆ
Line cord
ˆ
Lens Mount Security Screw (M6x10mm long, Qty. 2)
ˆ
Lens Mount Security Screw Driver (5mm Hex, Qty. 1)
ˆ
Warranty Card
ˆ
Web Registration Form