Section 1: SAFETY
GS Series User Manual
020-000724-02 Rev. 1 (10-2015)
1-1
1.
SAFETY
Read through this document in its entirety and understand all warnings and
precautions before attempting to operate the projector.
WARNING
.
•
Do not look into the projector lens when the laser is on. The bright light may
result in permanent eye damage.
•
To reduce the risk of fire or electric shock, do not expose this projector to
rain or moisture.
•
Do not open or disassemble the projector as this may cause electric shock.
•
All installation and maintenance procedures must be performed by a
Christie accredited service technician.
•
Keep all combustible material away from the concentrated light beam of the
projector.
•
Position all cables where they cannot contact hot surfaces or be pulled or
tripped over.
•
Always power down the projector and disconnect all power sources before
servicing or cleaning.
•
Use a soft cloth moistened with a mild detergent to clean the display
housing.
•
Disconnect the power plug from the AC outlet if the product is not being
used for an extended period of time.
•
Operate the projector under the following conditions:
-
Operating temperature range: 5°C to 35°C
-
Storage temperature range: -10°C to 60°C
-
Humidity range: 5% to 80 % RH (Max.), non condensing
-
Operating altitude: 10,000 ft. maximum
•
Use only the AC power cord supplied. Do not attempt operation if the AC
supply and cord are not within the specified voltage and power range for
your region.
•
Remove the lens plug from the lens opening in the projector before
installing the lens. Retain the lens plug to protect the optical components
from dust and debris during transport.
•
Do not block the ventilation slots and openings on the projector.
•
Do not use abrasive cleaners, waxes or solvents to clean the projector.
•
Do not allow anything to rest on the power cord.
