Section 3: INSTALLATION
GS Series User Manual
020-000724-02 Rev. 1 (10-2015)
3-13
3.7
Removing and Installing the Lens
When handling the projector after lens installation, make sure the front lens
cap is placed on the lens to protect the lens surface from potential damage.
When carrying or moving the projector, do not handle by the lens. This may
damage the lens, the chassis or other mechanical parts within the projector.
Installation Steps:
1.
Center the lens:
Ensure that the lens is at or near its center position.
Attempting to remove the lens when at a large offset may cause damage to
the lens assembly. Center the lens while the projector is switched on by
pressing the lens horizontal or vertical button and then pressing Enter.
2.
Turn Off the projector:
Turn the projector OFF.
3.
Wait for projector to cool down:
Allow the projector to cool down into
standby mode before replacing the lens. Remove power cord after the
projector has cooled down and prior to replacing the lens.
4.
Remove the lens:
Remove the lens ring cover.
Rotate the lens counter-clockwise by a quarter to release the lock. Remove
the lens through the front of the projector.
5.
Install the new lens:
Fully insert the lens assembly straight into the lens
mount without turning. Rotate the lens cap clockwise to lock the lens in
place.
