21
COMPONENT MAINTENANCE
(See also Users Manuals For Computer And Printer)
Other than cleaning, factory maintenance by qualified technicians is required for all components. Be sure system’s power is ‘off’ while
cleaning is performed. In dusty, or dirty environments, periodic cleaning is necessary. Specific instructions for cleaning critical compo-
nents are described below.
Wipe all parts clean using a lint-free, low-abrasion cloth using only an ammonia-based glass cleaner. Never use solvents or achol-
based cleaners of any kind on any part of the Laser Lock System.
Workstation Air Filters
After disconnecting Workstation power source, remove air filters and wash them in warm water and a mild detergent. Shake off excess
water, allow to dry, and reinstall.
Body Scanner Care
Do not plug or unplug cable from Body Scanner unless it is turned off.
Keep Body Scanner away from areas being undercoated, primed or painted. Keep heat away from
Body Scanner when using a torch for thermal stress relieving of structural components.
Clean all Body Scanner parts with a lint-free, low-abrasion cloth and a good quality glass or ammonia cleaner. Never use solvents or
alcohol-based cleaners on Body Scanner glass.
Care of Targets
Keep Targets away from areas being undercoated, primed or painted, and away from heat when using a torch for thermal stress reliev-
ing of structural components.
Use a lint-free, low-abrasion cloth and a good quality glass or ammonia cleaner to clean Targets. Do not use solvents.
Avoid scratching or gouging the Target’s reflective surface.
Summary of Contents for LASER LOCK
Page 43: ...43 Notes ...
