33
R S 2 32 C o m m u n ication cab le
Fig. 53. Connection of APPLIANCE MULTITESTER to PC
How to transfer stored data to PC
STEP 1. Connect APPLIANCE MULTITESTER to PC as shown in fig. 53 using appropriate RS 232 communication cable.
STEP 2. Open CE Link program on your PC.
STEP 3. Set baud rate (the same on PC and APPLIANCE MULTITESTER).
STEP 4. Use
↑
and
↓
keys to select one of displayed options and press Enter key
STEP 5. After pressing Enter key the selected function submenu is displayed at the bottom of menu:
5.5. SYSTEM CONFIGURATION
To reach System configuration menu the following procedure must be carried out:
STEP 1. Switch off the instrument turning ON/OFF key to OFF position.
STEP 2. Press SET UP key and keep it pressed while switching on the instrument.
STEP 3. System configuration menu is displayed (see figure below).
Fig. 54. Basic system configuration heading
STEP 4. Use
↑
and
↓
keys to select one of displayed options and press Enter key
STEP 5. After pressing Enter key on selected function message on the bottom of heading is displayed:
DATE and TIME setup:
■
Use Sel. and
↑
,
↓
keys to set day, month, year,
hour, minutes and seconds. Year must be set manually
at the beginning of each year when the time passes from
31.12 to 1.1. The warning “SYSTEM ERROR” is displayed
otherwise.
After Exit is selected the change will be confirmed and the
main system menu is offered to allow selection of other
functions or to exit to normal measuring mode.
SERIAL PORT BAUD RATE setup:
■
Use Sel. key to select appropriate baud rate from
9600, 19200 or 38400.
After exit, the new baud rate will be confirmed and basic
menu is displayed.
