C O N T R O L P A N E L S
In the PAUSE state, the wash cycles timer is stopped and the circulation pumps are shut off.
The heater is still working to maintain temperature. Pressing the cycle’s key again will
continue the cycle.
NOTE
: When a cycle is in the RUN or PAUSE state, pressing a different cycle key will start a new cycle.
When the wash cycle’s time has expired the system will enter the HOLD state.
In the HOLD state, the top display will show
C L E A N
and the system’s buzzer will start to
BEEP. Pressing the
STOP
key once will stop the buzzer, pressing it again will exit the
HOLD state and enter the OFF state.
The water circulation pumps are circulating at the holding speed and the heater is
maintaining the holding temperature.
NOTE
: All the cycle lights will flash indicating that a new wash cycle can be selected.
After a programmed amount of wash time the water is considered dirty and will need to be
changed. The top display will show
C H A N G E W A T E R
. Drain the tank to reset the system.
You are now ready to start another wash cycle.
Time Display
Since there is a large span of time that can be programmed in the various cycles and seconds
resolution may be required in the lower range, there must be 2 ways to display time.
If the time displayed is hours and minutes, then the display will show HH.MM (i.e.
4 . 3 5
is
4 hours and 35 minutes). If the time displayed is in minutes and seconds, the display will
show this as MM:SS (i.e.
4 : 3 5
is 4 minutes and 35 seconds).
Note:
The difference in using the
colon versus the period.
Wash Cycles
The system supports five wash cycles and every one has three steps defined within.
Each step has 4 different settings:
¾
Duration
¾
Water Temperature
¾
Pump Speed
¾
Soap Quantity
If a cycle is to be used, at least step 1 must be defined as having non-zero duration. If a
cycle’s step 1’s duration equals 0, then the cycle is not used, and its LED does not blink in
OFF mode.
Change Settings
To change the settings for a particular cycle, the unit must be in POWER UP or OFF mode.
Then, press and hold
both
the corresponding
CYCLE
and the
STOP
keys for 5 seconds.
29
Summary of Contents for Taskmaster PP-3
