C O N T R O L P A N E L S
Advanced Operation
Changing Temperature Set Point
The temperature set point is the water temperature setting for the wash tank and is the only
parameter that can be set by the operator. If the
TEMP
button is pressed once, the display
will switch back and forth from
sp
and
115
(115 represents the temperature setting and may
be different from your display).
Use the
UP
or
DOWN
buttons to change the temperature setting. Once set, press the
TEMP
button to lock in the new value.
NOTE:
If no key is pressed within three seconds, then your display will revert back to the way it was before
the TEMP button was pressed. If the temperature setting was changed and the TEMP button was not
pressed, then the temperature setting will remain unchanged.
Supervisor Mode
The supervisor mode can be accessed by holding the
TEMP
and
START/STOP
buttons
simultaneously for 3 seconds. The display will toggle
op
r
and
op.
b
. Pressing the
UP
or
DOWN
buttons will toggle between “
op.
b
”, “
op.s
”, “
cpi
.
”, and “
c
n
f
.
”.
To exit the supervisor mode, press the
UP
or
DOWN
buttons until
op.
b
is displayed, then
press the
TEMP
button.
NOTE
: You may need to hold the TEMP and START/STOP buttons in
for 3 seconds to get to the menu.
Setup Mode –
ΟΠ
.
Σ
Enter the supervisor mode and press the
UP
or
DOWN
buttons until
op.s
is displayed. Press
the
TEMP
button to select.
When prompted for a password (
pss
), use the
UP
and
DOWN
buttons to select
55
. Press
the
TEMP
button to enter in the value.
Press the
TEMP
button to toggle between the parameters that are available, see parameter
table below.
The parameter name and its value will be swapped in and out of the display. Press the
UP
and
DOWN
button to change the parameters value. Once a value has been changed, press
the
TEMP
key to lock in this value and move on to the next parameter. If you do not press
the
TEMP
key within three seconds after changing a parameters value, the new value will
not be saved.
Exit the supervisor mode when done with the setup mode.
NOTE:
See Supervisor Mode section
on how to exit.
15
Summary of Contents for Taskmaster PP-3
