Champion D10, Installation And Start-Up Data, Page: 21 / 55

D10.D15.DRS15-MANS
Apr ‘19
- 21 -
‘CSC300’ Controller
Description of Controller
The ‘CSC300’ Controller is the ‘brains’ of the D10, D15 and DRS 15 Rotary Screw Compressor Units. It monitors,
enables, and indicates the various functions of the Unit. The Controller voltage requirement is 24 volts +/- 15%.
The Controller is comprised of several levels of access, segregated into:
- Operator Level (Access Code: ‘2012’)
- indicates the main operating parameters (eg, temperature, pressure, etc) and faults of the unit.
-
Service 1 Level (Access Code: ‘2515’)
- allows access to change the Unit pressures, etc and indicates any Unit faults.
- an Access Code is required.
- Service 2 Level
- allows access to change some of the more restricted parameters.
- an Access Code is required.
- Factory Level
- allows access to areas of the Controller that only factory personnel can access.
- an Access Code is required.
Controller Operator Interface
Up
Scrolls up through
the parameters, or
increases the value
of a parameter.
Stop
Causes the Unit to
enter ‘Idle’ mode
and then shut off.
Down
Scrolls down
through the
parameters, or
decreases the value
of a parameter.
Reset
Allows the Unit to
be re-started after
an error has
occurred.
Escape
Allows you to move
back one menu
level.
Enter
Used to enter a
new page, etc, or
pressed to save
changes to a
parameter.
Start
Starts the Unit.
The Display above and at left indicates:
•
The system pressure is 135 psi
•
The Unit is unloading (not compressing air)
•
The Unit is running at 51% of its full speed
•
The remained Idling time is 23 seconds
•
The temperature of the oil leaving the Air End is 50.8°C.