![background image](http://html.mh-extra.com/html/champion/d10/d10_installation-and-start-up-data_2588306012.webp)
D10.D15.DRS15-MANS
Apr ‘19
- 12 -
Initial Start-up
1) Remove the LH Front Access Panel, and ensure
that there is sufficient Oil in the Oil Reservoir.
Refer to the ‘Lubrication’ section (page 8) in this
manual for proper type and level of Oil.
2) Do a visual inspection of the Unit, and ensure
that all fasteners are sufficiently tightened. This
must be done, as some fasteners may become
loose in transit.
3) Place the Fused Disconnect / Breaker in the ‘On’
position. Check that there is power to the
Controller
Start-up Procedures
Unit Controls
Do not place any materials in close proximity
to the Compressor. Placing materials against
or close to the Unit will limit the cooling
required, and could lead to premature failure.
4) During normal operation of the Unit, keep the
Access Panels closed at all times.
5) Ensure the Ball Valve on the Unit is closed, press
the ‘Start’ Button, and run the Unit up to
maximum pressure. The Unit will run up to
approx. 145 psi (10bar), at which point the Motor
will continue to run but not compress air.
6) Once the Unit reaches 145 psi (10bar), it will idle
for 5 minutes and shut off. For VSD units, the
unit will idle for 2 minutes and shut off.
7) Open the Ball Valve slightly and allow the air to
bleed from the Tank. Once the pressure reaches
approx 125 psi (8.6bar), the Unit will start and
begin to compress air after a short delay. For
VSD units, this pressure is 135 psi (9.3bar).
8) Measure the amp draw as the Unit reaches
maximum pressure.
9) Close the Ball Valve, allow the Unit to reach
maximum pressure, idle, and shut off. Once off,
check the various fittings etc inside the Cabinet to
ensure there are no internal leaks.
10) Once you are confident that there are no internal
leaks, the Unit will be ready for normal use.
11) To validate Warranty, complete the warranty
registration and attach to the on-line Startup
claim within Thirty (30) days of initial operation, or
email to:
‘
’
Shut off all power to the Compressor Unit
before attempting any repair or maintenance.
Adjusting the settings of the Controller could adversely affect
the performance of the Unit. Only those individuals with
knowledge of the Unit should make any adjustments.
Start Button
Allows the Unit to
start.
Stop Button
Use this to shut
the Unit off. Allows
the Unit to idle and
then stop after
several seconds.
Emergency Stop Button
Do not use to normally stop the Unit. To be used to
stop the Unit in emergencies only. Normal use will
damage electrical controls and Shaft Seal.
Summary of Contents for D10
Page 34: ...D10 D15 DRS15 MANS Apr 19 34 Variable Speed Drive cont d Menu Button Navigation Chart ...
Page 46: ......
Page 48: ......
Page 50: ......