6
A (1)
B (2)
max. 15mm
320001 (4 x 1m)
202097 (1m)
202127 PVC-NYLON (8 x 0.5m)
202134 PVC-NYLON (2 x 0.5)
1
2
1
2
default configuration
Installing the magnet bracket Steel Rack.
Identify your start and stop limit. Using the magnet
bracket mark two holes as shown above. Drill two
holes into the rack then install the spacers provided
into the back tabs using the raised pins to position.
Once the spacers are in place, fit the bracket over
the rack and tighten the screws. Install the start and
stop limit magnets as outlined above using the bolt
and nylex nut provided.
Installing the magnet and bracket for nylon
rack.
Identify your start and stop limit. Fit the bracket over the
rack and tighten the screws. Install the start and stop
magnets as outlined above using the bolt and nylex nut
provided.
Installing the Limit Magnets
Caution: The magnet limit switches are polarity sensitive and must be installed in the positions as marked
above, failure to do so will cause your motor to malfunction.
NOTE: If your gate opens to the LEFT Magnet 2 should be at the open limit, for a RIGHT hand opening gate
Magnet 1 must be position as the open limit as illustrated above.
Caution: You must have rack installed along the entire length of its travel including the start and stop limits
.
